The sex ratio represents the balance between the male and female populations. Ratios above 100 indicate a larger male population, and ratios below 100 indicate a larger female population. This measure is derived by dividing the total number of males by the total number of females and then multiplying by 100. It is rounded to the nearest tenth.

Beginning in 2006, the population in group quarters (GQ) is included in the ACS. Some types of GQ populations have sex distributions that are very different from the household population. The inclusion of the GQ population could therefore have a noticeable impact on the sex distribution. This is particularly true for areas with a substantial GQ population.

The Census Bureau tested the changes introduced to the 2008 version of the sex question in the 2007 ACS Grid-Sequential Test (http://www.census.gov/acs/www/Downloads/ACS-MP-09_Grid-Sequential_Test_Final_Report.pdf). The results of this testing show that the changes may introduce an inconsistency in the data produced for this question as observed from the years 2007 to 2008.

Beginning in 2008, the layout of the sex question response categories was changed to a horizontal side-by-side layout from a vertically stacked layout on the mail paper ACS questionnaire.

The median age is the age that divides the population into two equal-size groups. Half of the population is older than the median age and half is younger. Median age is based on a standard distribution of the population by single years of age and is shown to
the nearest tenth of a year. (See the sections on "Standard Distributions" and "Medians" under "Derived Measures.")

The age dependency ratio is derived by dividing the combined under-18 and 65-and-over populations by the 18-to-64 population and multiplying by 100.

The old-age dependency ratio is derived by dividing the population 65 years and over by the 18-to-64 population and multiplying by 100.

The child dependency ratio is derived by dividing the population under 18 years by the 18-to-64 population, and multiplying by 100.

Caution should be taken when comparing population in age groups across time. The entire population continually ages into older age groups over time and babies fill in the youngest age group. Therefore, the population of a certain age is made up of a completely different group of people in 2000 and 2008. Since populations occasionally experience booms/increases and busts/decreases in births, deaths, or migration (for example, the postwar Baby Boom from 1946-1964), one should not necessarily expect that the population in an age group in Census 2000 should be similar in size or proportion to the population in the same age group in the 2008 ACS. For example, Baby Boomers were age 36 to 54 in Census 2000 while they were age 44 to 62 in the 2008 ACS. Therefore, the age group 55 to 59 would show a considerable increase in population when comparing Census 2000 data with the 2008 ACS data. Beginning in 2006, the population in group quarters (GQ) is included in the ACS. Some types of GQ populations have age distributions that are very different from the household population. The inclusion of the GQ population could therefore have a noticeable impact on the age distribution. This is particularly true for areas with a substantial GQ population.

The 1996-2002 American Community Survey question asked for month, day, and year of birth before age. Since 2003, the American Community Survey question asked for age, followed by month, day, and year of birth. In 2008, an additional instruction was provided with the age and date of birth question on the American Community Survey questionnaire to report babies as age 0 when the child was less than 1 year old. The addition of this instruction occurred after 2005 National Census Test results indicated increased accuracy of age reporting for babies less than one year old.

The Census Bureau does not recommend trend analysis using the 2008 data with years prior to 2008 due to the questionnaire change.

The 2008 American Community Survey marks a break in the series of disability data. In the 1999 - 2007 American Community Surveys, hearing and vision limitations were captured with one question, referred in data products as "Sensory disability." As such, parsing out which limitation respondents identified with was impossible. In addition, research has showed that combining the two new measures to replicate a similar measure as the old one proved not comparable. For additional information on the differences between the 2008 ACS disability questions and prior ACS disability questions, see "2006 ACS Content Test Evaluation Report Covering Disability" (http://www.census.gov/acs/www/AdvMeth/content_test/P4_Disability.pdf).